Pagina 1 din 3 123 UltimUltim
Sunt afisate rezultatele de la 1 la 10 din 21

Thread: Compresor pentru Tornador

  1. #1
    Pasionat de detailing ciy's Avatar
    Data inscrierii
    martie 2013
    Locatie
    Constanta
    Varsta
    30
    Posturi
    89
    Thanks
    3
    Thanked 11 Times in 8 Posts
    Rep Power
    3

    Implicit Compresor pentru Tornador

    Īmi puteţi recomanda un compresor de aer pentru Z-020 ? Uz profesional/īndelungat.

  2. #2
    Pasionat de detailing
    Data inscrierii
    noiembrie 2010
    Locatie
    Pitesti
    Varsta
    38
    Posturi
    50
    Thanks
    3
    Thanked 8 Times in 8 Posts
    Rep Power
    5

    Implicit

    E foarte simplu.Uite aici o parere a unui coleg din state care a testat mai multe modele de compresoare:

    Heavy weight contender:

    10HP 120 gallon tank 2 stage rated at 175psi at 35cfm

    OK obvious overkill, this compressor would probably run a few Tornadors. I quit measuring after 3 minutes of wide open use. Pressure never went below 90psi, motor never started.


    Middle weight:

    5Hp 80 gallon, 2 stage, 175psi at 19cfm

    At 3 minutes the pressure hadn't dropped below 90 to the gun. Motor was able to fill tank and kick off with trigger pulled.


    Light weight:

    "5hp" 25 gallon, 125psi, 90 psi at 7.1cfm

    This poor compressor has been abused, abandened, and left outside for at least 10 years. I am not even sure if it is safe, but I pulled it in to the shop for a quick test. It charged up to 145psi and would run the Tornador for 45s before the motor would kick on. It would run the Tornador for a full 2 minutes before the pressure would drop below 70psi. At that level the Tornador becomes to underpowered for proper use.


    Bantem:

    "2hp, 4 gallon, 4.3cfm @100psi

    Pushing the lower limit of usefulness here. While this will run a finish nailer with no problems. Using it to power the Tornador to clean a carpet would not be efficient. It would power the Tornador for about 9 seconds before it would kick on, the good thing was that it only needed 12 seconds to fully charge. This compressor could be used with the Tornador to clean dashes, maybe even door jams. Anything that needs the blast then wipe method. I think the small tank was the problem here.


    Conclusion: A large storage tank or a high cfm compressor is the key to getting maximum benefit from the Tornador. A large tank would allow you to blast around with the Tornador, then wipe clean with a rag while recharging the tank. Since large tanks are cheaper than high cfm compressors, go with the biggest tank you can find. I would recomend at least a 5cfm compressor with a 10 gallon tank at the minimum, a 25 gallon tank would be even better.




    Z-020 Tornador Black Car Cleaning Gun, Z-020 Tornador Black

    Din manualul lui aflam ca ai nevoie de un compresor care sa se incadreze in urmatoarele cerinte tehnice:

    Technical Data
    Air inlet 1/4"
    Air pressure 90 psi / 6,3bar
    Air consumption 245 l/min at 78 psi / 5.5 bar
    Weight 0.67 Kg.
    A weighted emission sound pressure (LpA) 92.66 dB (EN ISO 15744)
    A weighted sound power level (LwA) 103.65 dB (EN ISO 15744)
    Peak-C-weighted Spitzenschalldruck (LpC) 96.5 dB (EN ISO 15744)
    Vibration level
    Measurement uncertainty (Standard)
    3.9 m/sec
    2 (EN 28662-1)

    1.95 m/sec² (EN 28662-1)

    La compresoare eu unul iti recomand orice model care sa aibe butelia mai mare de 150l si debitul de aer refulat exact cat scrie mai sus.Peste acest debit iti tb regulator de presiune.Sub acest debit jucaria functioneaza sub capacitate si nu prea ai spor cu ea.Eu unul folosesc un compresor de 3 cp, cu 2 pistoane si butelie de 50l dar care are debitul cerut de tornador.Intrucat la mine e mai mult pasiune nu ma deranjeaza butelia.Vorbeste cu PustiulK sau cu Polish Sibiu .Ei il folosesc la modul la care iti doresti tu si iti pot spune ce anume model de compresor sa cauti.

  3. #3
    Pasionat de detailing ciy's Avatar
    Data inscrierii
    martie 2013
    Locatie
    Constanta
    Varsta
    30
    Posturi
    89
    Thanks
    3
    Thanked 11 Times in 8 Posts
    Rep Power
    3

    Implicit

    Eu gasisem ceva brand italian cu o butelie de 320L la cca. 1700 RON cu ceva discount (pret de catalog cca. 2300 RON). Posibil sa fi fost acest model http://www.vendaria.ro/ProductDetail...oductKey=85269 dar nu prea imi inspira fiabilitate.

    Alte sugestii ? Buget ... pana la 3000 RON.

  4. #4
    Pasionat de detailing PushtiulK's Avatar
    Data inscrierii
    septembrie 2012
    Locatie
    Bucuresti
    Varsta
    31
    Posturi
    525
    Thanks
    295
    Thanked 583 Times in 204 Posts
    Rep Power
    4

    Implicit

    Eu folosesc un compresor cu o butelie de 100 litri, 2.2 kw (3 hp) si maxim presiune 10 bari.

  5. #5
    Pasionat de detailing ciy's Avatar
    Data inscrierii
    martie 2013
    Locatie
    Constanta
    Varsta
    30
    Posturi
    89
    Thanks
    3
    Thanked 11 Times in 8 Posts
    Rep Power
    3

    Implicit

    PushtiulK: are aceleasi specificatii ca cel din linkul postat de mine mai sus. Face fata fara probleme pentru uz mai indelungat ?

  6. #6
    Pasionat de detailing PushtiulK's Avatar
    Data inscrierii
    septembrie 2012
    Locatie
    Bucuresti
    Varsta
    31
    Posturi
    525
    Thanks
    295
    Thanked 583 Times in 204 Posts
    Rep Power
    4

    Implicit

    Fix pe acesta il am: http://www.scule.detop.ro/Compresoar...326-l-min.html

    Il am de 3 ani, i-am schimbat de 2 ori uleiul, in rest absolut nici o problema cu el. Il folosesc frecvent cu tornadorul, doar ca nu il tin in garaj cand lucrez cu tornadorul. Tornador Black este mai putin pretentios decat prima versiune.

  7. #7
    Pasionat de detailing ciy's Avatar
    Data inscrierii
    martie 2013
    Locatie
    Constanta
    Varsta
    30
    Posturi
    89
    Thanks
    3
    Thanked 11 Times in 8 Posts
    Rep Power
    3

    Implicit

    Modelul acesta l-am luat si eu pana la urma.
    Imagini Atasate Imagini Atasate

  8. #8
    Pasionat de detailing PushtiulK's Avatar
    Data inscrierii
    septembrie 2012
    Locatie
    Bucuresti
    Varsta
    31
    Posturi
    525
    Thanks
    295
    Thanked 583 Times in 204 Posts
    Rep Power
    4

    Implicit

    Bun, sa il folosesti cu placere. Sa il ti in alta incapere decat cea unde lucrezi, pt ca va scoate un zgomot infernal.

  9. #9
    Pasionat de detailing ciy's Avatar
    Data inscrierii
    martie 2013
    Locatie
    Constanta
    Varsta
    30
    Posturi
    89
    Thanks
    3
    Thanked 11 Times in 8 Posts
    Rep Power
    3

    Implicit

    Nu prea am cum, daca face mult zgomot, ii fac o .. cusca ? si o izolez fonic.

  10. #10
    Pasionat de detailing PushtiulK's Avatar
    Data inscrierii
    septembrie 2012
    Locatie
    Bucuresti
    Varsta
    31
    Posturi
    525
    Thanks
    295
    Thanked 583 Times in 204 Posts
    Rep Power
    4

    Implicit

    Da, construieste o cusca si izoleaz-o bine fonic, deoarece va fi crima si pedeapsa sa lucrezi cu compresorul la interior .

Pagina 1 din 3 123 UltimUltim

Reguli de Postare

  • Nu poti creea thread-uri noi.
  • Nu poti sa raspunzi
  • Nu poti sa adaugi atasamente
  • Nu poti sa iti modifici posturile
  •